Mounting The Handles; Operation; Energy Saving Tips; Storing Bottles - Dometic MoBar300S Bedienungsanleitung

MoBar300S/550S
7

Mounting the handles

➤ Proceed as shown (fig. 6, page 7).
8

Operation

8.1

Energy saving tips

• Do not open the beverage center more often than necessary.
• Do not leave the beverage center's door open for longer than necessary.
• Clean dust and dirt from the condenser at regular intervals.
8.2 Notes on the location
• The device should not be exposed to direct sunlight as this can lead to higher power consumption.
• The ground must be level and sufficiently stable to bear the device at full capacity.
• The device must be sufficiently ventilated. The ventilation slots on the front of the device must not be
obstructed.
• The device is designed for use at an ambient temperature range of 0 °C to +38 °C (+32 °F to +100 °F).
8.3

Storing bottles

• Store only bottles and cans that are closed and still sealed.
• Do not overload the device.
• Store the bottles as shown (fig. 7, page 8).
• Do not cover the shelves with aluminium foil or any other objects, as this obstructs the air circulation.
• After a power outage or if the device has been switched off, wait 3 to 5 minutes before switching on the device
again.
8.4 Operating the device
➤ Mounting or detaching the speed rail (fig. 8, page 9).
➤ Mounting or detaching the extension table (accessory for MoBar550S) (fig. 9, page 10).
➤ Using the rotomolded ice basket (fig. 0, page 11).
➤ Emptying the rotomolded ice basket (fig. a, page 12).
➤ Connecting to the power supply (fig. b, page 13).
➤ Switching on/off the beverage center (fig. c, page 13).
➤ Switching on/off the light when the door is open (fig. d, page 14)
➤ MoBar51SZAC only: Switching on/off the light independent whether the door is open or closed (fig. e,
page 14).Changing temperature unit (°C/°F) (fig. f, page 14).
➤ Changing temperature (fig. g, page 15).
➤ Indicating the set temperature (fig. h, page 16).
➤ Removing the storage shelves (fig. i, page 17).
EN
Mounting the handles
25