Original Accessories / Tools; Preparing The Product For Use; Connecting The Compressed Air Source; Loading The Magazine - Parkside PDT 40 B2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Safety of the fastener driving tool / Preparing the product for use / Operation
When loosening the hose coupling, hold the
hose firmly in your hand to prevent injuries
caused by a rebounding hose.
Be absolutely certain to use a ¼'„ threaded
nipple and a quick-release coupling for the
compressed air connection.
Never place your hands near the mouth when
the device is ready to operate. Otherwise inju-
ries may result.
Pay attention to damage. Check the de-
vice for damage before bringing it into use. If
the device exhibits defects, it must not be oper-
ated under any circumstances.
Do not use any pointed objects. Never
insert pointed and / or metal objects into the
inside of the device.

Original accessories / tools

Use only the accessories and attachments
detailed in the operating instructions.
The use of fasteners or other accessories other
than those recommended in the operating in-
structions could lead to you suffering an injury.

Preparing the product for use

NOTE: always wear the protective goggles sup-
plied before putting the tool into operation. Remove
the protective film from the protective goggles before
using for the first time.
Connecting the compressed
air source
NOTE: The compressed air tacker must only be
operated with cleaned, oil-misted compressed air
and must not exceed the maximum operating pres-
sure of 8 bar. The compressor must be fitted with a
pressure reducer in order to regulate the operating
pressure.
Connect the device to a suitable compressed
air source.
All manuals and user guides at all-guides.com
1. To do so, press the compressed air hose quick-
2. Connect the other end of the compressed air
1. Press the magazine lever
2. Insert the corresponding fastener (nails, see
01
02
3. Slide the magazine cover forwards until it locks.
release coupling (not included in the scope of
delivery) on the ¼" threaded nipple
compressed air tacker.
Locking is automatic.
hose to the (filter) pressure reducer on the com-
pressor.

Loading the magazine

azine cover back to its stop position.
Fig. 01 or staples, see Fig. 02) into the maga-
zine .
5

Operation

Load the magazine of the compressed air
5
tacker as described in the chapter "Loading the
magazine".
Use the pressure reducer to set the correct
operating pressure.
Ensure that the permissible operating pressure
of 8 bar at the device is never exceeded.
Operating pressure that is too high does not
of the
4
and pull the mag-
12
5
5
GB 33