Dmx Operation - EuroLite TMH BSW-380 Moving-Head Beam/Spot/Wash Bedienungsanleitung

System
Dis Ver
With this function, you can display the software version of the display.
MT Ver
With this function, you can display the software version of the PCB.
DMX monitor
With this function, you can display the current DMX addresses of the channels.
System errors
With this function, you can display error messages.
Total fixture hours
With this function, you can display the running time of the device.
Partial fixture hours
With this function, you can display the temporary running time of the device from the last power on.
Total lamp Hours
With this function, you can display the total operating hours of the illuminant.
Partial Lamp Hours
With this function, you can display the operating hours of the illuminant from the last power on.
180° / display reverse
With this function, you can flip the display by 180° for a better view when the fixture is hung from the truss or
a ceiling.
Display language select
With this function, you can select the desired display language (English or Chinese).

DMX operation

Setting the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 26 control channels.
However, it can also be switched to a mode with 22 channels if different functions are required. To be able to
operate the device with a DMX controller, the DMX starting address must be set. The starting address
depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Press the MENU button until the display is lit and you can select Setting with the MENU button. Confirm
with the ENTER button.
2 Press UP or DOWN button so many times until DMX address is indicated on the display. Confirm with
the ENTER button.
3 Use the buttons UP and DOWN to set the address. Confirm with the ENTER button.
4 In order to set the desired DMX channel mode, press the UP or DOWN button so many times until
Channel mode is indicated on the display. Confirm with the ENTER button.
5 Use the buttons UP and DOWN to set the desired DMX channel mode: 26 CH (26 DMX channels) or 22
CH (22 DMX channels). Confirm with the ENTER button.
6 With the MENU or ENTER buttons, you can return to the main menu.
7 The DMX Mode control indicator next to the display will light up when DMX signals are being received.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronously.
37/44 00138311, Version 1.0