Step 3
Pull the rear end of the shelf sup‐
port away from the side wall and
remove it.
Step 4
Install the shelf supports in the op‐
posite sequence.
The retaining pins on the telescopic
runners must point to the front.
13.3 How to use: Pyrolysis
Clean the oven with Pyrolysis.
WARNING!
There is a risk of burns.
Turn off the oven and wait
until it is cold.
Step 1
Turn on the oven.
Option
1
2
3
When the cleaning starts, the oven door is locked and the lamp is off.
To stop the cleaning before it is completed, turn off the oven.
The oven stays locked until it is cold.
Turn off the oven and wait
until it is cold.
13.4 Cleaning reminder
The oven reminds you when to clean the
oven with: pyrolytic cleaning.
- flashes in the display for 10 sec after
each activation and deactivation of the oven.
24
ENGLISH
If there are other appliances installed in
the same cabinet, do not use them at the
same time as this function. It can cause
damage to the oven.
Before the Pyrolysis:
Remove all accessories.
Step 2
Set: Pyrolysis.
Cleaning mode
Light cleaning
Normal cleaning
Thorough cleaning
When the cleaning ends:
Clean the cavity with a soft cloth.
You can deactivate the reminder. Refer to
"Additional functions" chapter, Using the
settings menu.
2
1
CAUTION!
Clean the oven floor and the inner
door glass with warm water, a soft
cloth and a mild detergent.
,
- press to set the cleaning
mode. Press:
Remove the residue from the bottom
of the cavity.
Step 3
.
Duration
1 h 30 min
2 h
2 h 30 min