Setting The Force; Cooling Water - struers AbraPlan-10 Gebrauchsanweisung

Setting the Force

Cooling Water

AbraPlan-10
Instruction Manual
Note: the Process time is automatically
D
disabled.
Push knob to accept the new value.
The Stock removal process has a 15 minutes time-out. If
D
the prescribed amount of material has not been removed
within this time, the process stops automatically.
Turn knob to select Force setting.
D
D
Push knob to display square brackets [ ] and turn knob
to change the Force setting.
D
Push knob to accept the new value.
The cooling water pump will automatically start when the
preparation process is started. To stop the pump, press F1.
All the value and function settings defined in the GRINDING SETUP menu
are saved in the AbraPlan-10's memory. Therefore, if the power to the
machine is interrupted, these values are remembered.
Please Note
21