Removing The Optional Serial Module - Dell OptiPlex 3000 Thin Client Servicehandbuch

Steps
1. To remove the dummy metal bracket, insert a flat-head screwdriver in the hole of the bracket, push the bracket to release
the bracket, and then lift the bracket out from the system.
2. Connect the HDMI module cable to the connector on the system board.
3. Insert the HDMI module into the optional module slot from the inside of the computer chassis.
4. Replace the two (M3X3) screws to secure the HDMI module to the system.
Next steps
1. Follow the procedure in
2. Install the side cover.

Removing the optional Serial module

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
About this task
The following image indicates the location of the optional Serial module and provides a visual representation of the removal
procedure.
26 Entfernen und Einbauen von Komponenten
after working inside your
before working inside your
computer.
computer.