Installing The Sma Antenna Assembly (Location 3) - Dell OptiPlex 3000 Thin Client Servicehandbuch

Steps
1. Remove the screw (M3x3) that secures the SMA antenna assembly to the system and lift it away.
2. Push the SMA antenna assembly inside from the opening on the back view and lift it away from the system.

Installing the SMA antenna assembly (Location 3)

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the SMA antenna assembly and provides a visual representation of the removal
procedure.
NOTE: To upgrade to SMA antenna, the internal antenna (Location 3) is required to be removed.
Entfernen und Einbauen von Komponenten 37