Herunterladen Inhalt Inhalt Diese Seite drucken

Digital Effects Processor; Installation; Cable Connections - Behringer XENYX X1204USB Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für XENYX X1204USB:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 36
18
XENYX X1204USB/1204USB User Manual

3. Digital Effects Processor

Fig. 3.1: Digital effects module (only X1204USB)
24-BIT MULTI-EFFECTS PROCESSOR
Here you can find a list of all presets stored in the multi-effects processor.
This built-in effects module produces high-grade standard effects such as
reverb, chorus, flanger, delay and various combination effects. The integrated
effects module has the advantage of requiring no wiring. This way, the danger
of creating ground loops or uneven signal levels is eliminated at the outset,
completely simplifying the handling.
These effect presets are designed to be added to dry signals. If you move the
FX TO MAIN control, you mix the channel signal (dry) and the effect signal.
This also goes for mixing effects signals with the monitor mix. The main
difference is that the mix ratio is adjusted using the FX TO MON control. Of course,
a signal has to be fed into the effects processor via the FX control in the channel
strip for both applications.
◊ ◊
On the following page, you will find an illustration showing how to
connect your foot switch correctly.
LEVEL
The LED level meter on the effects module should display a sufficiently high
level. Take care to ensure that the clip LED only lights up at peak levels. If it is
lit constantly, you are overloading the effects processor and this could cause
unpleasant distortion. The FX control (AUX SEND 2) determines the level that
reaches the effects module.
PROGRAM
You can select the effect preset by turning the PROGRAM control. The display
flashes the number of the current preset. To recall the selected preset, press the
button; the flashing stops. You can also recall the selected preset with the
foot switch.

4. Installation

4.1 Cable connections

You will need a large number of cables for the various connections to and from
the console. The illustrations below show the wiring of these cables. Be sure to
use only high-grade cables.
¼" TS footswitch connector
strain relief clamp
sleeve
tip
sleeve
pole 1/ground
tip
pole 2
The footswitch connects both poles momentarily
Fig. 4.1: ¼" TS connector for foot switch

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Xenyx 1204usb

Inhaltsverzeichnis