Material / type of
Softwood
work
Coarse finish
60
(Grit grade)
Fine finish (Grit grade) 240
Preselected rotation
high (5–6)
speed
Material / type of
Hardwood
work
Coarse finish
60
(Grit grade)
Fine finish (Grit grade) 180
Preselected rotation
high (5–6)
speed
Material / type of
Chipboard
work
Coarse finish
60
(Grit grade)
Fine finish (Grit grade) 150
Preselected rotation
high (5–6)
speed
Material / type of
Removing paint /
work
varnish
Coarse finish
60
(Grit grade)
Fine finish (Grit grade) ––
Preselected rotation
high (5–6)
speed
Material / type of
Sanding varnish
work
Coarse finish
150
(Grit grade)
Fine finish (Grit grade) 320
Preselected rotation
low (1–2)
speed
All manuals and user guides at all-guides.com
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 120
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 240
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 150
Preselected rotation
speed
Q
Rust removal
40
medium / high (3–4)
Plastic
120
low / medium (2–3)
Non-ferrous metals
(e.g. aluminium)
80
medium / high (3–4)
Stationary use
Set the speed using the belt speed wheel
Turn the power tool as shown in figure E and
place on a sturdy worktop.
Attach two screw clamps
as shown and tighten.
Tips and tricks
N ever use the same sanding belt to sand wood
and metal.
W orn or ripped sanding belts can damage
the workpiece. Change sanding belts at the
appropriate time.
K eep the sanding belt properly tensioned so
that it does not hang down too much and
become unusable due to nicks, creases etc.
Operation
.
1
to the power tool
12
GB
11