Nouvag Mesher Bedienungsanleitung Seite 29

Mesher, skin expansion system
Manual For manual disinfection place the Mesher, ratchet and blade roll in an RKI*-tested disinfectant. (Action
disinfection time according to the disinfectant manufacturer's specifications).
* RKI disinfectant list (Robert Koch Institute).
Drying If a drying program is not provided by the washer-disinfector, the Mesher, ratchet and the blade roll have
to be dried manually or in a drying cabinet.
Inspection, Perform a visual inspection for damage, corrosion and wear. Treat bearings and bushings with a drop of
assembly and biocompatible oil. Install blade roll in the Mesher and close the bridge.
maintenance
Packaging Individually:
Autoclave in a vacuum autoclave at max. 135°C for at least 5 minutes. When sterilizing several
Sterilization
instruments in one sterilization cycle, do not exceed the sterilizer's maximum load. A drying cycle must
be added in case of autoclaves without a post-vacuum function. Dry Mesher in the Stericase for at least
1 hour at room temperature.
* The temperature hold times are based on the country-specific guidelines and standards.
Storage No special requirements. If the sterilized Mesher is not used immediately following sterilization, the
Stericase must be marked with the sterilization date. It is advisable to add a sterilization indicator.
The above-mentioned instructions were validated as suitable from NOUVAG AG. The person accomplishing the treatment is responsible that the treatment that
actually took place leads to the desired results in the treatment facility with the available equipment, materials, and personnel. To ensure this it is normally necessary
to validate and supervise the process. Each deviation from the instructions provided should be evaluated carefully with regard to effects and negative consequences.
Operating instructions Mesher, Ref. 31584, V32/15
Enclose Mesher and ratchet in the Stericase with new paper filter.
EN
11