RUSTA 156500080101 Gebrauchsanweisung Seite 14

Paddle to Adventure
FIN TYPE:
We have three ways to install fins, which can be chosen according to the actual situation.
Your SUP either has a Bravo Fin or Smart Lock Fin System. Please check your fin type and follow
the necessary instructions.
MONTERINGSANVISNING
ASSEMBLY CONSTRUCTION
TIP: Before you begin please ensure the fin box slot is clean and free of sand and grit.
1. Placera den vikta brädan på en plan yta och vik upp den.
1. Place the folded board on a flat surface and unfold.
Screw Fin
2. Fäst den stora fenan enligt bilden nedan.
2. Attach the large fin as shown in the picture below.
3. Se till att ventilens centrum är i läget "upp och stängd".
3. Be sure that valve core is in the "up and closed" position.
4. Anslut ventilen och pumpen. Blås upp pumpen till högt tryck (12–15 psi).
4. Connect the valve and pump. Inflate the pump to high pressure (12–15 psi).
Figure 1.
Slide Fin
Figure 1.
MINST 12 PSI FÖR KORREKT ISUP-DRIFT OCH HÖGST 15 PSI FÖR DENNA PRODUKT.
US Fin
MINIMUM 12 PSI FOR PROPER ISUP OPERATION AND MAXIMUM OF 15 PSI
FOR THIS PRODUCT.
Dra åt ventillocket efter uppblåsning. Endast ventillocket kan säkerställa
ultimat lufttäthet.
After inflation, tighten the valve cap. Only the valve cap can ensure ultimate air tightness.
TIPS: Om pumpkolven börjar gnissla kan du applicera lite spraysilikon på kolvaxeln.
TIP: If the pump piston starts to squeak, apply some spray silicone to the piston shaft.
MAXIMALT LUFTTRYCK FÖR DENNA PRODUKT ÄR 15 PSI.
MAXIMUM AIR PRESSURE FOR THIS PRODUCT IS 15 PSI.
Figure 1. VARNING! BLÅS INTE UPP TILL MER ÄN 15 PSI. DETTA
WARNING! DO NOT INFLATE BEYOND 15 PSI.
KAN SKADA PRODUKTEN OCH ORSAKA PERSONSKADOR.
Unscrew the plate from the screw (Figure 1) and place into the fin slot via the gap (Figure 2).
THIS CAN DAMAGE THE PRODUCT AND CAUSE INJURY.
TIP: Use the screw to slide the plate into place along the slot.Insert the fin into the fin box slot
via the central gap, slide the fin to the back and firmly push down the other end (Figure 3).Line
up the screw with the screw plate and tighten until fully secure (Figure 4).
14
6
IM_156500080101_Inflatable_standup_paddle_board_v1.indd 14
IM_156500080101_Inflatable_standup_paddle_board_v1.indd 6
Slide the fin into the
fin box.Make sure fin
and card slot of fin
box in the same
position.
Figure 2.
Slide the fin into the
fin box.Make sure fin
and card slot of fin
box in the same
position.
Figure 2.
Figure 2. Figure 3.
CENTER FIN
Place the bolt in the
chute and rotate tightly
to ensure that the fin
do not fall off.
Insert the gasket into
the slot to ensure that
the gasket can catch
the fin.
Figure 4.
6
2021-10-05 13:55
2021-10-05 13:55