Zwilling FRESH & SAVE VACUUM PUMP Bedienungsanleitung Seite 40

EN
Problem
Pump stops during the vacuuming process and the indicator light lights up red.
Or: Liquids were accidentally drawn in by the pump.
Remedy
• The pump sucked in liquids during the vacuum sealing process. Do not turn the pump upside
down. Shake the pump slightly to remove any liquid. Make sure the pump is completely dry.
Press the pump ON/OFF button for two seconds to reset it. Other fluids may leak. Check
whether the pump can be switched on again afterwards. Repeat this procedure if the pump
stops again.
For more information on the products, visit our FAQ page at:
http://www.zwilling.com/fresh-and-save-faq.html
40
Troubleshooting