Setting Up The Track Diagram Control Screen - Märklin Central Station 3 Bedienungsanleitung

Setting up a Track Diagram Control Screen
In this section, you will become familiar with all of the necessary steps for setting up a track diagram
control screen in the Central Station 3. The simple track diagram of a Märklin starter set (see Page 24) will
serve as an example that we will model step-by-step on the following pages.
Adding a Panel
You create the basis for the track diagram control screen with a TDCB section. First, activate the edit
mode by tapping in the upper right on the tool symbol („Edit") and then select „Edit Track Board Page". In
the tool bar now turned on tap on „Track Diagram/ Area" in the drop-down menu on „Add TDCB Section".
Tip: You can shift the tool bar if you pull the 9-dot symbol on its right side with your finger to the destination
position.
Enter a name for the new Track Diagram Control Board Section in
the dialog field turned on and confirm with „Ok".
Important: Select the designation sensibly. The name for the board
cannot be changed later.
Deleting a Panel
The new board is already created,
here in the example with the name
„Maerklin". This board can be de-
leted again with a tap of your finger
on the wastepaper basket symbol
in the center of the board – so long
as it is empty and the edit mode is
active. You will recognize it from two
features: from the light gray plus
symbol laid over the board and from
the green circle with a check mark
at the foot of the tool symbol.
Changing the Size of the Panel
Pulling Solenoid Items from the Item List onto the Panel
Moving Solenoid Items on the Panel
The board can be enlarged or
reduced in size with the help of the
small black circles visible on every
side of the board.
In order to make the board the
size of the display, tap on one of
the circles, hold your finger on the
display, and pull your finger to the
edge of the screen. Repeat this for
the other three sides. Done! Now
you have enough room to set up the
simple track diagram (see Page 24)
described on the following pages.
Now pull the required solenoid items
from the item list onto the board that
has been created: the turnouts W1R,
W2L, and W3R as well as the signals
S1 and S2. To do this touch the symbol
in question, pull your finger to the
center of the display, and lift it again
from the screen. The track diagram edit
mode must continue to be activated for
these steps.
The turnout W1R has its place in the
upper left section of the board in the
planned track diagram (see Page 24).
Therefore, pull the turnout into this
area by touching the turnout symbol
and pulling your finger upward on the
display. The light blue circle around the
turnout indicates that you have select-
ed the turnout by tapping on it.
21