Märklin Central Station 3 Bedienungsanleitung Seite 74

Managing the USB Connections and Memory
Tip: Always use this eject option in order to prevent data loss on your USB stick before you pull the USB
stick from the CS3 again.
Central Stations: Integrating Other CS Controllers
Link S88
In this section, you will see the USB devices
connected to the CS3. Using a tap of your
finger change between the devices in the
first line. Tap on the name field in question
in order to assign a descriptive name. Touch
the eject icon in order to delete the USB
device (small image).
You can assign an individual designation
in the Central Station settings. More-
over, you can set the interval of how
frequently the device's status is queried.
Standard setting: every five seconds.
The ID is automatically assigned. In
the case of a new device replacing a
defective device, enter the value here
for the old device.
You define the interval in the settings
for the Link S88 how frequently the
feedback module queries the status.
Standard: every five seconds. Here
too you can change the designation.
The CS3 assigns the ID automatically.
In the case of a new Link S88 replacing
a defective unit, enter the value here for
the old unit.
Configuring Booster Connections
Integrating the Connect 6021 Control Units
Deleting Device Settings No Longer Required
The CS3 remembers the settings for each device that was once connected to it. The advantage:
You can separate all of the devices from the CS3 without losing their settings. You can delete
these settings if necessary with the wastepaper basket. This icon can be found in the system
settings in the section „Settings" for each device. You remove the device's data with a tap of
your finger on the icon. That device will no longer be shown in the system settings.
You can change the interval between
two status queries in the Boost-
er settings. Standard: every five
seconds. In addition, you can set
individually the designation as well
as the transformer being used and
the desired Mix Mode. Wipe with
your finger in the direction of the
upper edge of the screen in order to
see the lower sections of the page.
You can adjust the status query interval if
necessary in the information and settings
segments. Tap on the plus symbol in the
„Locomotives" segment in order to add lo-
comotives. Select with a tap of your finger in
the selection window that is turned on (small
image). Locomotives that have been added
will appear after that in the lowest position
(left image).
34