Märklin Central Station 3 Bedienungsanleitung Seite 57

Adding a Signal
Tap in the item list on the tool symbol and select „Add Article" (left
image) in the drop-down menu that opens in order to set up a signal.
Then tap on „Signals" (right image) and open the settings (lower
image).
Here you can set the details for the new signal item:
Name the signal.
Select the type of signal.
Select decoder.
You determine the type of signal by means of a
drop-down menu that you open up with a tap of
your finger. Different signal variations are there
ready to be selected.
Tap on „Ok" adds the
signal.
Set the address – if it is shown
in red, the address is already
assigned.
Select the protocol.
You can do other settings in the
tab „Set Up". Here you select
the type of decoder and you
can also change the switching
duration.
The tab „Con-
figuration" is
intended for
experts and is
not relevant for
normal operation.
Adding a Light
A new light item is quickly set up: A drop-down menu opens
with a tap of your finger on the tool symbol for the item list
(„Edit"). Here you select „Add Article". Tap on „Light" (images
to the left) in the menu that opens.
Adding a Turntable
A turntable is also easily put into the item list: A drop-down menu opens
with a tap of your finger on the tool symbol for the item list („Edit"). Here
you select „Add Article" (left image). Tap on „Turntables" in the menu
that follows.
Now, all of the settings (name, address, type,
protocol, decoder, or type of decoder, and switch-
ing duration) can be edited: in the tabs „Info" (left
image) and „Set Up" (lower image).
Now you have
access to all of
the settings in the
tabs „Info" (name,
address, type,
protocol, and de-
coder) (left image)
and „Set Up" (type
of decoder and
switching duration)
(right image).
17