Changing Lubricant Type / Refilling - struers RotoForce-4 Gebrauchsanweisung

Changing Lubricant Type /
Refilling
RotoForce-4
Instruction Manual
Set the mode switch on Lupo to STOP
Remove Lupo from RotoForce.
Hold the Lupo lubricant bottle firmly and remove the top lid.
Empty the bottle, still mounted on Lupo, of any remaining
lubricant.
−
Fill the bottle with mild, soapy water.
−
Put Lupo back on the supporting arm.
−
Set the mode switch on Lupo to START
−
Set the dosing control to max. dosing (step 10) and let the
water run through the nozzle for 2-3-min.
Repeat the above points but fill with tap water to rinse out
any soap residue.
Refill with lubricant and remount the top lid.
Always avoid turning the socket cap while unscrewing the Lupo bottle, as the
turning movement may cause damage to the socket cap gasket.
o
position.
IMPORTANT
s
.
13