Transport, Packaging And Storage; Safety Information For Transportation; Transport Inspection; Packaging - GCE druva MPLH0XD0 Gebrauchsanleitung

If the manifold has the opportunity for inert gas purging (MSLH0XSE, MSLHEXSE), the high pressure area
of the manifold can be purged to remove contaminates before initial start-up or before cylinder or bundle
change. The manifold version with inert gas purging is only available in stainless steel.
The described system is mounted on a stainless steel plate. Due to plate dimensions all components are pro-
tected against damage inside of package, during transport and in mounted condition. The two plates design
enables to mount the component easy and with less weight.
The cut-outs in the front plate enable to change the gauge without disassembly of the complete manifold. At
EN
the back plate at both sides are holes to connect the cylinder hoses with carabiner hook. To connect ground-
ing you can find screw at the ground plate.
The development, construction and production testing is according to the following standards:
- Regulators- ISO 7291
- Valves- ISO 10297
- Gauges EN 837-1
- Mechanical explosion prevention of complete manifold- ISO80079-36; IEC 60079-32-1; TRGS 727

5. TRANSPORT, PACKAGING AND STORAGE

TIPS AND
•
The installation and start- up of this gas supply panel is normally done by the supplier or by authorized
personnel.
•
Even though there can be some users or maintenance personnel who care about the packaging. The fol-
lowing notes should be observed accordingly.

5.1. SAFETY INFORMATION FOR TRANSPORTATION

NOTE!
•
Damages caused by inappropriate transportation!
•
If transported inappropriately, consignments can fall or topple over. This can cause considerable property
damage.
•
When unloading the consignments on delivery and transporting them on the premises, act with caution
and observe the symbols and warnings on the packaging.
•
Use only the attachment points provided.
•
Do not remove the packaging until you are ready to assemble the regulator.

5.2. TRANSPORT INSPECTION

Upon delivery, check immediately that the consignment is complete and has not been damaged during tran-
sit. Procedure on detection of visible transport damage:
•
Refuse acceptance of the delivery or only accept subject to reservation
•
Record the extent of the damage on the transportation documentation or on the forwarder's delivery note
•
File a complaint
TIPS AND RECOMMENDATIONS!
•
Report each and every defect as soon as you discover it. Claims for damages can only be asserted within
the specified periods.

5.3. PACKAGING

The individual consignments are packed according to the anticipated transport conditions. Without exception
all packaging is made of environmentally friendly material.
The packaging is intended to protect the individual components against transport damage, corrosion and
other damage until they are ready for installation. Do not, therefore, destroy the packaging; only remove it
when assembly is imminent.
NOTE!
•
Risk of environmental harm through incorrect disposal!
RECOMMENDATIONS!
26/72