Remote Control; Changing The Batteries - GUTMANN ESTRELLA II EM 06 Bedienungsanleitung

en

Remote Control

ON/OFF (1)
To switch on, press the field with the ON/
OFF symbol. The fan runs at the 1. level.
To switch off, press the ON/OFF symbol
again.
Increasing fan power (2)
Press the symbol Increase fan power.
The fan power is increased by one level
each time the field is pressed.
Reducing fan power (3)
Press the symbol Reduce fan power. The
fan power is reduced by one level each
time the field is pressed until level 1 is
reached.
Lighting (4)
Press the button with the lighting symbol
to switch on the lighting. The lighting is
switched off by pressing the button again.
The lighting is dimmed by pressing and
holding the lighting symbol.
Intensive level (5)
Maximum fan power is reached by press-
ing the button Intensive level. The fan
power switches back by one level after 5
minutes.
Automatic follow-up time (6)
The automatic follow-up time is activated
by pressing the field with the Follow-up
time symbol. The follow-up time symbol
(LED) lights up. The cooker hood contin-
ues to run for approx. 15 minutes and
gradually switches back one step every 5
minutes (from the last step set) before it
finally switches off.
Filter saturation (f): (1)
After 15 operating hours, the red grease
filter saturation indicator (in the control
unit) flashes . The grease filter must be
cleaned. After cleaning the filter, hold
down the (1)~ 15 sec. key until the red
indicator light goes out.
in ON mode - TW function is deactivated
when the red LED flashes ! )
16
int
( The unit must be
Colour temperature setting
( depending on the variant )
The colour temperature of the LED
lighting can be infinitely adjusted between
2700K and 6500K.
Press and hold the delay button (6) to
adjust, the LEDs start to change the
colour temperature. When the desired
setting is reached, release the button, the
colour setting is saved.
1
2
3

Changing the batteries:

The battery cover is located on the back
of the remote control. Unscrew the Phil-
lips screw and lift it with thumb and index
finger until the magnetic contact which
holds the battery cover is released. Now
remove the empty batteries and replace
them with the same type. Replace the
battery cover and screw it tight. Attention:
Dispose of empty batteries properly !
Technical data
Dimensions: 230 x 34 x 10
Battery: 2 lithium batteries CR 2032 3 V
Infrared range: ~ 2 m
4
5
Reset filter satu-
ration display:
6
ON / OFF button
~ 10sec. Press
until the red LED
goes out!