Product Description; The Remote Control - GUTMANN SOMBRA II Bedienungsanleitung

Product description

1 Hood body
2 Lighting
3 Glas front
4 Filter
5 Control panel
6 Sensor
7 LED Indicadors
Instruction Manual
The functions of the hood as well as the
power level of the external motor can be
controlled in two different ways:
1. Operation via remote control
(recommended)
2. Operation via switch

The remote control

(six control fields.)
ON/OFF (1)
To switch on, press the field with the
ON/OFF symbol. The fan runs at the 3.
level. To switch off, press the ON/OFF
symbol again. Grease filter saturation
limit: Button pressures (~15sec.) to a
red LED goes off !
Increasing fan power (2)
Press the symbol Increase fan power.
The fan power is increased by one level
each time the field is pressed.
Reducing fan power (3)
Press the symbol Reduce fan power.
The fan power is reduced by one level
each time the field is pressed until level
1 is reached.
Lighting (4)
Press the button with the lighting symbol
to switch on the lighting. The lighting is
switched off by pressing the button
again. The lighting is dimmed by press-
ing and holding the lighting symbol.
Colour temperature setting TW (6)
The colour temperature of the LED light-
ing can be infinitely adjusted between
2700K and 6500K.
Press and hold the delay button (6) to
adjust, the LEDs start to change the
colour temperature. When the desired
setting is reached, release the button,
the colour setting is saved.
Intensive level (5)
Maximum fan power is reached by
pressing the button Intensive level. The
fan power switches back by one level
after 5 minutes.
Automatic follow-up time (6)
The automatic follow-up time is activat-
ed by pressing the field with the Follow-
up time symbol. The follow-up time sym-
bol (LED) lights up. The extractor hood
switches from level 3 back top level 1
and runs at this level ~15 minutes be-
fore switching off.
Grease filter cleaning display
If the grease filter indicator lights up (red
LED), the filter must be cleaned. After
cleaning the filter, hold down the ON/
OFF switch (1) on the remote control or
the toggle switch (fan symbol) on the
hood for at least 10 seconds. The indi-
cator light goes out.
EN
13