Computer Functions - AsViva TP01-Z01 Benutzerhandbuch

COMPUTER FUNCTIONS

With these computers you can extend our trampoline to make your exercises even more effective. It
provides important information such as your pulse rate, number of jumps, training time and your calo-
ries burned. If the number of jumps is not equal to the number of jumps possible after tensioning the
spring ( snap hook ).
To turn on your computer, press the Mode or Reset button.
The display shows the time and the number of jumps ( count ) by default.
Both values are initially set to 0.
During your training you can decide which value you want to display.
Press the Mode button to switch between the following values:
• Pulse
Shows your current pulse. Please note that only one value will be displayed here if you have
fastened your chest strap and placed it correctly.
• Scan
With this setting the display changes every 5 seconds between Pulse / Time / Calorie.
• Time
Time spent in your current training session
• Calorie
Your calories consumed so far are shown here. Please note that this is an estimated value
and actual consumption may vary.
When you leave the jumping surface of the trampoline or stop jumping, the data is paused. If you do
not continue your training within 3 minutes, your display will go into standby mode.
In this case, you must press the Mode / Reset button to turn on the computer again.
You can then continue your training with the previous values.
To reset the values, press the Reset button once.
26