AsViva H21 Benutzerhandbuch Seite 47

ASSEMBLY
Figure 6.1:
ASSEMBLY SADDLE SUPPORT TUBE & SADDLE
STEP 1: Loosen the knob(A1) and keep saddle support tube(D) into the mainframe(IN) the saddle sup-
port tube is equipped appropriately.
Attention: Please make sure the knob has been equipped exactly into the adjusting hole of the saddle
support tube(D).
STEP 2: Equip the saddle(G) with the seat basement(D1) by the preinstalled nuts(G1) and washer(G2)
on the bottom of the saddle(G).
ASSEMBLY FOR BOTTLE HOLDER
Release the screw(U3) from the support tube(F)
support tube(F) and secure it by screw(U3). Then put the water bottle (U2) into the bottle holder(U1).
F
G
D1
D
U2
U1
U3
D2
then assembly the water bottle holder(U1) on the
G2
G1
A
TOOL
47