Cleaning And Maintenance - lamber DSP1 Installation Bedienung

CLEANING AND
MAINTENANCE
PRECAUTION
INSTRUCTIONS
- IMPORTANT : Before carrying-out the cleaning
and maintenance operations, disconnect the
equipment from the mains power supply:
- high temperatures can be reached inside the
machine (90°C). ASfter power supply has been
removed, wait until the machine has reached the
room temperature, before working on it.
- the machine protection degree is IP21, therefore
it should not be washed with direct high pressure
jets of water;
- never leave tools, parts or other loose material
on or in the machine;
- BEFORE starting machine or cycle, after any
maintenance or repair work, make sure all
protective are correctly installed;
DAY MAINTENANCE
- Disconnect the machine with pushbutton "A";
- Lift the overflow pipe and let the water
drain out of the tank;
- Wash thoroughly the
housing to remove all impurities;
- Take the filters and clean it under running
water;
- Re-assemble the overflow
filters in their housings;
POSSIBLE TROUBLES - CAUSES - SOLUTIONS
PROBLEMS
The machine doesn't catch
The water doesn't go in
Insufficient Washing
Insufficient Rinsing
bar - 100 kPa;
CAUTION! FOR ANY OTHER TROUBLE, CALL SERVICE
PREVENTIVE
AND CLEANING
tank and the filters
pipe and the
CAUSES
Main switch is switched off;
Water cock closed;
The Overflow is not in its place;
place;
Wrong detergent or dosage
insufficient;
Low temperature in the tank;
Dirt wash filter;
Rinsing nozzles blocked;
Hydraulic pressure lower than
a booster pump;
- Check and clean the washing and the rinsing
jets
ATTENTION! Daily disassemble the lower and
upper wash arms by working on the „big"
ring nut, like in the picture.
- Clean the outer surface of the machine by
using a wet sponge; don't use water jets
because, beside being dangerous they could
damage the electrical parts; don't use abrasive
detergents;
- When the machine is to remain idle
long time, drain all the water
boiler (the
lower side of the boiler)
electropump. Also leave the
open.
Attention. Before carrying out cleaning the
inside of the machine, make sure that there are no
foreign objects that could damage the rusty steel inside
the tank. The eventual rust particles could come from
non-stainless steel dishes, from baskets or damaged
water pipes not rust-proof.
NEVER WASH THE EXTERNAL PART
MACHINE WITH A WATER JET
SOLUTIONS
Turn ON the main switch;
Open water cock;
Reassemble the Overflow in its
Use anti-foam detergent in the
right dosage and never with
cold water;
Wait untill the water gets hot;
Clean filter;
Unscrew and clean nozzles
under running water;
Wait till the pressure is on or buy 1
20
from
drain plug is located on the
and from
wash
for a
the
the
tank
OF THE