Technical Data; Technical Inspection / Calibration Check; Explanation Of Symbols - Visomat Handy Gebrauchsanweisung

E

3. Technical data

Model: visomat handy
Size: 6,8 cm x 6,8 cm x 3,0 cm
Weight: 103 g without batteries
Display: LCD display (liquid crystal display)
Memory: 2 memories each capable of storing 90 readings
(stored automatically) and average value (AVG)
Measurement procedure: Oscillometric determination of systole, diastole
and pulse
Pressure display range: 0-299 mmHg
Measurement range: Diastolic: 15-160 mmHg
Systolic: 40-240 mmHg
Pulse measurement: 40-199 pulses/minute
Measurement precision: Blood pressure measurement (cuff pressure): ± 3
mmHg, Pulse rate: ± 5 %
Power supply: 2 x 1.5 V AAA LR03 alkaline manganese batteries
Operating conditions: Ambient temperature 5 to 40 °C, rel. air humidity
15 to 93 %, air pressure 700 to 1060 hPa
Storage and transport Ambient temperature -25 to 70 °C, rel. air humidi-
conditions: ty up to 93 %, air pressure 700 to 1060 hPa
Automatic switch-off: 60 seconds
IP code: IP 22: Protected against solid foreign particles
with a diameter of more than 12.5 mm, protection
against water droplets
Protection against Internal power supply, applied part type BF (cuff )
electric shock:
Expected service life: 5 years
Operating mode: Continuous operation
Classification: Internal power supply by battery

4. Technical inspection / calibration check

Generally, it is recommended that a metrological inspection is per-
formed every two years. However, professional users in Germany are
obligated to do so in accordance with the "Medical Products Operator
Ordinance" (Medizinprodukte-Betreiberverordnung).
EN-48
Technical information Technical information
This can be performed either by UEBE Medical GmbH, an authority re-
sponsible for metrology or an authorised maintenance service. Please
refer to your national regulations.
Upon request, responsible authorities or authorised maintenance ser-
vices receive a "Test instruction for metrological inspection" from the
manufacturer.
Please only submit the device for metrological inspection together
with the cuff and the instructions for use.
Important: No modifications, e.g. opening the device (except to re-
place the batteries), may be made to this device without the manufac-
turer's permission.

5. Explanation of symbols

This product complies with Council Directive 93/42/EEC of 5
September 2007 concerning medical devices and bears the
0123
mark CE 0123 (TÜV SÜD Product Service GmbH).
Degree of protection against electric shock TYPE BF
Consult the instructions for use
Serial number
Reference number = item number
Protected against solid foreign particles with a diameter of
IP22
more than 12.5 mm, protection against water droplets.
Direct current
Manufacturer
E
EN-49