For Your Safety; Unit Features; Function Description - Pilz PSEN cs1.13p ATEX Bedienungsanleitung

PSEN cs1.13p ATEX

For your safety

}
Do not remove the connector's protective cap until you are just about to connect the
unit. This will prevent potential contamination.

Unit features

}
Transponder technology for presence detection (safety function)
} Pilz coding type: Coded
} Dual-channel operation
} 2 safety inputs for series connection of multiple safety switches
} 2 safety outputs
}
1 signal output
}
LED display for:
–
–
–
}
4 directions of actuation

Function description

The safety outputs may have a high or low signal, depending on the position of the actuator
and the signal status of the inputs.
In a safe condition there is a low signal at the safety outputs.
Electrical states of the inputs and outputs (when switch is ready for operation:
Power / Fault LED is green):
Actuator in
the re-
sponse
range
Yes
Yes
No
Operating Manual PSEN cs1.13p ATEX
21097-2EN-13
WARNING!
Loss of safety function due to manipulation of the interlocking device
Manipulation of the interlocking device may lead to serious injury and death.
– You should prevent any possibility of the interlocking device being
manipulated through the use of a spare actuator.
– Keep the spare actuator in a safe place and protect it from unauthor-
ised access.
– If spare actuators are used, these must be installed as described in
Installation [
State of the actuator
State of the inputs
Supply voltage/fault
Safety input
S11
High
Low
X
39].
Safety input Safety out-
S21 put 12
High High
Low Low
X Low
Safety out- Signal out-
put 22 put Y32
High High
Low High
Low Low
31