Supplementary Data; Radio Approval; Order Reference - Pilz PSEN cs1.13p ATEX Bedienungsanleitung

PSEN cs1.13p ATEX
Operating EN ISO
mode 13849-1:
2008
PL
2-ch. OSSD PL e
All the units used within a safety function must be considered when calculating the safety
characteristic data.

Supplementary data

Radio approval

USA/Canada
PSENCS1
FCC ID: VT8-
PSENCS1
IC: 7482A-
FCC/IC-Requirements:
This product complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standards.
Operation is subject to the following two conditions:
1) this product may not cause harmful interference, and
2) this product must accept any interference received, including interference that may cause undesired operation.
Changes or modifications made to this product not expressly approved by Pilz may void the FCC authorization to operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
Le présent produit est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) le produit ne doit pas produire de brouillage, et
(2) l'utilisateur de le produit doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.

Order reference

Product type
PSEN cs1.13p/PSEN cs1.1
PSEN cs1.1
Operating Manual PSEN cs1.13p ATEX
21097-2EN-13
EN ISO EN 62061
13849-1:
SIL CL
2008
Category
Cat. 4 SIL CL 3
INFORMATION
A safety function's SIL/PL values are not identical to the SIL/PL values of
the units that are used and may be different. We recommend that you use
the PAScal software tool to calculate the safety function's SIL/PL values.
Features
Safety switch with transpon-
der technology, coded, with
actuator with assured oper-
ating distance 15 mm
Actuator with transponder
technology
EN 62061 IEC 61511
PFH [1/h] SIL
D
4,10E-09 SIL 3
Connection type
8-pin M12 connector
IEC 61511 EN ISO
13849-1:
PFD
2008
T [year]
M
1,10E-04 20
Order No.
540 005
540 080
46