Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
Safety
A WANDERS source of heat is more than just a stove in your room; the flue and the exterior wall and/or roof duct are also part
of the heating system. Only when your gas appliance is installed with the concentric flue designed by M&G or Metaloterm can
we guarantee that your appliance is burning safely.
Every gas appliance by WANDERS is installed with a thermocouple interrupter. This will prevent unexpected gas flow if the
pilot light has gone out.
Here are some recommendations for safely using your gas stove:
•
Only use your gas appliance if it is properly closed. If the glass is broken, you must not use the fireplace.
•
Prevent small children or the infirm from getting too close to a burning stove and do not leave them alone in the room when
the stove is burning. You could use a fire-screen.
•
Put the ignition knob on the 'small flame' symbol to put the remote control out of operation while the pilot flame stays alight.
This will ensure that no one can accidentally put the appliance higher or lower.
•
Never allow children to play with the remote handset.
•
Do not pour or put combustible liquids and materials on the log set, as it may damage the fireplace beyond repair.
•
Do not place any combustible materials, such as curtains, close to the fireplace.
•
The gas appliance must be repaired with original parts only, and by a certified installer.
•
If for any reason the pilot light goes out, you must wait 5 minutes before igniting the appliance again.
•
Requirements for distances to the surroundings and the advised hearth measurements can be found on page 58-60.
Guarantee
The guarantee conditions can be found on page 83.
Installation instructions
Your gas fireplace may only be installed by a qualified installation mechanic in combination with the concentric channel
system recommended by WANDERS (M&G or Ontop Metaloterm). Only then will the fireplace be approved in accordance
with the European CE directive for appliances burning gaseous fuels. We do not offer a warranty if the gas stove has been
connected and/or installed incompletely or incorrectly. The channel system consists of an inner channel with a diameter
of 100 millimetres and an outside channel with a diameter of 150 millimetres. The flue gases are exhausted outside via the
inner 100-millimetre channel through natural draught, while combustion air is supplied between the 100-millimetre and
150-millimetre channels.
The appliance may only be installed and connected by a certified installer in accordance with the standard gas installation
instructions and the installation requirements mentioned below. Furthermore, the national and local rules and regulations on
placing and using closed gas appliances shall be applicable. Only a certified installer has the authority to change the setting
values (in accordance with the requirements) and to carry out any other adjustments.
Before installing the appliance, the installer must check whether the information on the type tag of the fireplace
corresponds with the gas type and gas pressure to which the appliance is connected. If it does not match, you
are not allowed to connect the gas appliance.
Placing
The gas fireplace can be placed in a crack-free and/or mechanically ventilated home without difficulty. There is no need for
extra ventilation for combustion or for a smoke and fire vent. Waste gases are discharged by natural draught via the inner pipe
into the open. The oxygen needed for burning the fire is supplied from the space between the pipes. This is the reason that no
insulation must be placed between the inner and outer pipe.
The gas heater is not suitable for a built-in setup and should be mounted to a sufficiently sturdy wall or placed
on a sufficiently sturdy floor.
20
Werbung
Inhaltsverzeichnis
