Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CArE InstruCtIons
1. Check if the two plugs (plug of the controller (E) and plug of the heating pad (F)) are connected to each
other. If they are not, connect them to each other. To operate the heating pad, insert the power plug (A) into
the power socket.
2. In order to set the desired temperature, slide the temperature control (D) to the desired level (0 = OFF,
1 = low temperature, 2 = medium temperature 3 = maximum temperature). On the display screen (C),
the set level is now shown.
3. The heating pad switches off automatically after approx. 90 minutes.
4. In order to restart the heating pad after the operating time has expired, you must set the temperature control
(D) to "0". After 10 seconds, you can start it by setting the temperature again.
5. After use, please disconnect the power plug from the power socket.
6. Move the selector switch to position 1 or 2 before falling asleep or any continuous use.
trouBLEsHootInG
Problem
The device is not connected to
the power supply system
The device does not
The device is not switched on
warm up.
The device is defective
CArE InstruCtIons
•
Before cleaning the heating pad, the power plug must be disconnected from the power socket.
•
In order to clean the heating pad, open the snap buttons on its cover and pull out the heating pad.
•
The heating pad and its cover can be washed by hand or in the washing machine at 40° C using a
mild detergent.
•
Do not iron the heating pad.
•
Please do not use any detergents containing chlorine.
•
Do not dry clean the heating pad.
•
The heating pad and its cover cannot be tumble dried.
•
Do no use any high-pressure cleaners.
•
Make sure that the controller does not come into contact with any liquids. Liquids may result in damage.
•
Never use the heating pad while it is wet or damp. The heating pad must not be switched on while it is
drying.
•
Let the heating pad air dry. Do not use any auxiliary means (such as clothes pegs) to hang it up to dry. This
may damage the cables inside.
storage and regular inspection
•
Do not crumple the heating pad. Carefully fold the product to store it.
•
Store the device in a dry place when it is not in use.
•
Allow the device to cool before you fold or roll it up.
•
Inspect the device and the power cable for possible signs of wear or damage at regular intervals.
Cause
Insert the power plug into the power
socket and switch on the device
Switch on the device
Send the device to the manufacturer
troubleshooting
DE
EN
FR
IT
ES
NL
RU
PL
SE
FI
Werbung
Inhaltsverzeichnis
