Service Data; Installation - JUNO JB094C9 Benutzerinformation

Problem
The water in the cavity em‐
bossment does not boil.
The water comes out of the
cavity embossment.
The display shows "12.00".

Service data

If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

INSTALLATION

WARNING! Refer to Safety
chapters.
Possible cause
The temperature is too low.
There is too much water in
the cavity embossment.
There was a power cut.
on the front frame of the oven cavity. Do
not remove the rating plate from the oven
cavity.
.........................................
.........................................
.........................................
Remedy
Set the temperature at least
to 110 °C.
Refer to "Hints and tips"
chapter.
Deactivate the oven and
make sure that the appli‐
ance is cold. Wipe the water
with a cloth or sponge. Add
the correct amount of water
to the cavity embossment.
Refer to the specific proce‐
dure.
Reset the clock.
27