JUNO JB094C9 Benutzerinformation Seite 25

2. Lift and turn the levers fully on both
hinges.
3. Close the oven door halfway to the first
opening position. Then lift and pull
forward and remove the door from its
seat.
4. Put the door on a soft cloth on a stable
surface.
5. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
2
B
6. Pull the door trim to the front to
remove it.
7. Hold the door glass panel by its top
edge and carefully pull it out. Make
sure the glass slides out of the
supports completely.
8. Clean the glass panels with water and
soap. Dry the glass panels carefully.
Do not clean the glass panels in the
dishwasher.
When the cleaning is completed, install
the glass panel and the oven door.
The screen-printing zone must face the
inner side of the door. Make sure that after
the installation the surface of the glass
panel frame on the screen-printing zones
is not rough when you touch it.
When installed correctly the door trim
clicks.
Make sure that you install the internal
glass panel in the seats correctly.
25
1
A