Operation; Starting And Stopping The Engine; Mowing; Working Instructions - FLORABEST FBM 135 A1 Originalbetriebsanleitung

Operation

Observe the noise protection and
local regulations.
Starting and Stopping the En-
gine
Warning! Petrol is flammable.
Start the engine at least 3 m
away from the filling location.
Check the petrol and oil levels
regularly (see "initial operation")
and refill in time.
Start the equipment on a sturdy,
level base, if possible not in long
grass. Ensure that the cutting tool
is touching neither objects nor the
ground.
Start the Engine:
1. For a cold start, pull the
cold start lever (choke) (4)
towards you.
2. Pull the safety catch (3) towards
the handle bar and hold it.
3. Pull the starter cord (28) and the
engine starts.
4. When the engine starts, allow
the starter handle (28) to slowly
slide back into the starter cable
guide (27).
5. Push the cold start lever
(choke) (4) back to the ini-
tial position.
Stopping the Engine:
6. Release the safety catch (3),
the engine stops and the blade
is slowed.

Mowing

1. Start the engine (see
2. Wheel drive on: pull the drive
catch (1) towards the handle
bar (2). The mower moves for-
wards.
3. Wheel drive off: release the
drive catch (1). The equipment
stops.

Working Instructions

General Working Instructions

• As far as possible, mow the lawn when
it is dry in order to protect the turf.
• Set the cutting height such that the
equipment is not overloaded.
• Run the equipment at walking speed
in lines that are as straight as pos-
sible. For uninterrupted mowing, the
lines should always overlap by a few
centimetres.
• Do not move backwards.
• On slopes, always work across the
slope.
• If the blade comes into contact with
a foreign body, switch off the engine
immediately. Wait until the blade is
stationary and check the equipment
for damage. Restart work only if the
equipment is undamaged.
• Switch off the equipment during long-
er breaks and for transportation and
wait until the blade is stationary.
• Clean the equipment after each use,
as described in the "cleaning and
maintenance" chapter.
GB MT
).
67