Assembling The Grass Box; Operation; Hanging On / Removing The Grass Box; Adjusting The Cut Height - FLORABEST FRM 1200 D3 Originalbetriebsanleitung

GB IE
5. Clip the cable holder (see
8) into the bar (3) and to the
curved handle (1) and thus fix
the cable.
When both wing nuts are loosened,
the curved handle can be folded down
for storing the equipment. Ensure
that the power cable is not caught.

Assembling the Grass Box

Wear protective gloves when
mounting the grass collection
box in order to avoid injury.
D
1. Connect the two pieces of the
collection box (4).
2. Connect the handle (15) in one
of the two pieces of the collection
box (16). The arrow markings on
the handle (15) and at the top
of the grass grass (16) show the
alignment of the handle (15).
Do not work with the lawn mower
without impact protection. There is
a risk of injury.
We recommend always using the
grass box when working with the
lawn mower, otherwise the mowing
result may be significantly impaired.

Operation

Hanging On / Removing the
Grass Box
E
1. To hang on the grass box (4), lift the
collision guard (7) and hang on the
grass box. Fold the collision guard
(7) onto the grass box (4). It holds
the grass box in the correct position.
26
A
2. To remove the grass box (4),
The level gauge (
side of the grass catcher (4).

Adjusting the Cut Height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
The lawn mower can be set to the follow-
ing cut heights by means of three position
changes of the front and rear wheels, ad-
justing the individual wheels:
The single wheel adjustment has
always to be at least at one axis.
60 mm - Tall cutting height
40 mm - Medium cutting height
20 mm - Short cutting height
F
1. Unscrew the wheels (5).
2. Screw the wheels (5) back on in
The correct height is around 20 – 40 mm
for a decorative lawn and around
40 – 60 mm for a used lawn.
lift the collision guard (7) and
detach the grass box. Fold the
collision guard (7) back onto the
mower housing (6).
D
20) is located on the
D
Flap ( 20) open:
grass catcher (4) empty
D
Flap ( 20) closed:
grass catcher (4) full
the desired position. The screw
connections (5.1) have to be used
to attach and detach the wheels.
The single wheel adjustment has
always to be at least at one axis