Delivery Contents; Initial Operation; Installing The Handle Bar; Installing The Starter Cord - FLORABEST FBM 135 A1 Originalbetriebsanleitung

Delivery Contents

Carefully unpack the appliance and check
that it is complete:
- Petrol lawn mower (pre-assembled)
- Collapsed handle bar
- Grass collection box
- Cable clamp
- Assembly accessories for fixing the
bar
- Spark plug wrench
- Quick guide
- Operating instructions

Initial Operation

Caution! Risk of injury from
rotating blades. Carry out work
on the equipment only when the
blade is switched off and sta-
tionary.
Before starting the equipment, you must
- Install the handle bar
- Install the grass collection box
- Install the starter cord
- Fill with engine oil
- Fill with petrol

Installing the Handle Bar

Caution! When installing the
handle bar, ensure that the
Bowden cables (
squashed.
1. Position the ends of the bottom
handle bar (6) in the two bar
slots (30) on the lawnmower.
2. Use the enclosed assembly ac-
cessories to screw the bottom
handle bar (6) to the bar slot
(30).

Installing the Starter Cord

Installing the Grass Collection
Box
9) are not
3. Fold out the top handle bar (2).
4. Lock the quick release tension-
ing levers (26) by pressing them
towards the top handle bar (2).
The tensioning levers must be
tightened and in contact with
the bar such that tensioning is
possible with average force.
To loosen the tensioning lever,
turn the nut (31) on the tension-
ing lever anticlockwise.
To tighten the tensioning lever,
turn the nut on the tensioning
lever clockwise.
5. Fix the Bowden cables (9) to the
bar using the cable clamp (7).
1. Pull the safety catch (3) towards
the handle bar (2) and hold it.
2. Slowly pull the starter cord on
the starter handle (28) towards
the bar and hook the starter cord
into the starter cord guide (27).
3. Release the safety catch (3).
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
installed incompletely. Risk of
injury!
Remove the Protective Caps:
1. Remove the protective caps
(32) on the grass collection box
(24).
Fixing the Grass Collection
Box onto the Equipment:
2. Lift the rear impact protection (8).
GB MT
65