Settings; Setting Of The Amount Of Coffee; Setting Of The Display To Show Cups Of Litres; Setting Of The Prewet Function - Animo M-LINE M200 Betriebsanleitung

5. SETTINGS

WARNING
• The jug will overflow if the set coffee quantity is too high.
• The manufacturer is unable to accept any liability for the
consequences of altered settings.
5.1

Setting of the amount of coffee

Both the M and the MT models are supplied as standard set to make coffee using 1.8
litres of water (14 cups). If this is too much or too little, or if you are using an MT model in
combination with a thermos jug with a greater capacity, you can adjust the quantity as fol-
lows:
1. Press the selection button (5.4) and hold it in, and then press the start/stop button
(5.5) once. A number will appear in the display.
2. Release both buttons. The display will show the set value. The standard setting is
20 (1.8 l. / 14 cups).
3. Press the selection button (5.4) to increase the amount. Each increase in the display
puts approximately 4 ml more water in the jug. Use the table at the back of this
manual. To reduce the quantity: go through the table until it restarts after 50.
The range runs from 0, 1, 2, 3, 4.... 50.
4. Now wait for 6 seconds. The selected quantity is has been saved.
5.2 Setting of the display to show cups or litres
The appliance is factory set to display the number of cups.
If you want the display to show litres, you can adjust it as follows:
1. Press the selection button (5.4) and hold it in, then press the start/stop button (5.5)
once. A number will appear in the display.
2. Release both the buttons and then press the start/stop button once again.
3. A "C" (Cups) will appear in the display. Change the "C" to an "L" with the selection
button.
4. Now wait for 6 seconds. The adjustment has been saved.
5.3

Setting of the prewet function

This appliance can make coffee using two methods:
Continue-brew ("Cb ") (factory setting); The coffee making process begins immediately
and will pour hot water over the ground coffee without a waiting time.
Prewet-brew ("Pb"); part of the hot water is first poured onto the ground coffee. This
causes the coffee to rise so that the smells and flavours are released. The coffee making
process then begins. If you want to set the appliance to Prewet brew, this setting can be
changed as follows:
1. Press the selection button (5.4) and hold it in. Then press the start/stop button once.
A number will appear in the display.
2. Release both buttons and then press the start/stop button twice.
"Cb" (Continue-brew) will appear in the display.
3. Use the selection button to change "Cb" into "Pb" (Prewet-brew).
4. Now wait for 6 seconds. The adjustment has now been saved.
GB
33
M-LINE
2015/02 Rev. 4.0