Installation; Preparation For Positioning The Appliance; Electrical Connection; Connection To The Water Mains - Animo M-LINE M200 Betriebsanleitung

M-LINE
3.2

Installation

CAUTION
• Water always remains in the heating system: for this
reason the appliance must not be placed in an area
where the temperature can fall below freezing point.

3.2.1 Preparation for positioning the appliance

- Position the appliance at buffet height on a firm, level base that can bear the weight
of the appliance when it is filled.
- Position the appliance level and in such a way that it cannot cause any damage if it
leaks.
- The water supply pipe (G3/4" pipe 15mm) and the power connection must be
situated within half a metre of the appliance.
- The owner must have these installation-technical preparations performed by qualified
engineers in accordance with general and local regulations.
- The service engineer may only connect the appliance to the prepared connections.

3.2.2 Electrical connection

Supply voltages and frequencies can differ between countries. Check if the appliance is
suitable for connection to the local power mains. Check if the details on the type plate
correspond. Connect the appliance to an earthed wall socket.

3.2.3 Connection to the water mains

Connect the appliance using the water hose to an easily accessible aeration tap that can
be quickly closed if problems arise.

3.2.4 Water drainage (18)

If the reservoir of the coffee maker is overfilled owing to a defect, the excessive water will
be discharged via the water drain (18) at the bottom of the appliance. Make allowance
for this when positioning the appliance!
WARNING
• Ensure that the mains lead does not come into
contact with the hot plates (if present).

3.2.5 first time use

When used for the first time the appliance works according to the standard factory set-
tings. The various settings can be altered by authorised personnel. See chapter 5.
Settings.
2015/02 Rev. 4.0
28
GB