Operating Elements And Connections - EuroLite LED KLS-1001 Bedienungsanleitung

4.2 Operating elements and connections

1
Fixation screw
2
Fuse holder for power outputs
Only replace the fuse when the device is disconnected
from mains. Only use fuses of the same rating and
power. The correct value is specified on the device.
3
Sensitivity control for the microphone
4
LED display
5
Power input with fuse holder
• Used to plug the supplied power cord in.
• Only replace the fuse when the device is disconnected
from mains. Only use fuses of the same rating and
power. The correct value is specified on the device.
6
Jacks POWER OUTPUT 1 to 4
IEC jacks for power supply of further devices.
7
Microphone for sound-controlled operation
8
Control buttons
• button MENU to call the menu items
• button DOWN to switch between sound control and
automatic mode
• button UP to switch to DMX operation
• buttons UP and DOWN to set the speed in automatic
mode and to set the DMX starting address
9
Connector for the foot pedal FP-1
10
Jack DMX IN
DMX signal input (3-pin XLR) for connecting a DMX
controller
11
Jack DMX OUT
DMX signal input (3-pin XLR) for connection to the DMX
input of another light effect unit
12
LED spot 1 to 4
13
Connection cable for the control unit
14
TV pin for placing on a stand
15
Fixation screw
23/31 00056665.DOC, Version 1.2