Operating Elements And Connections - EuroLite LED KLS-2500 Bedienungsanleitung

4.2 Operating elements and connections

1
Fixation screw
2
QuickDMX input
DMX signal input (5-pin XLR) for connecting a
wireless QuickDMX receiver. The connector
provides the required 5 V operating voltage.
3
Microphone for sound-controlled operation
4
OLED display
5
Jack DMX IN
DMX signal input (3-pin XLR) for connecting a DMX
controller.
6
Jack DMX OUT
DMX signal input (3-pin XLR) for connection to the
DMX input of another light effect unit.
7
Jacks POWER OUTPUT 1 to 4
IEC jacks for power supply of further devices.
8
Fuse holder for power outputs
Only replace fuses when the device is disconnected
from mains. Only use fuses of the same rating and
power. The correct value is specified on the device.
9
Control buttons
10
Connector for the foot pedal FP-1
11
Power input
Used to plug the supplied power cord in.
12
Fuse holder for power input
Only replace the fuse when the device is
disconnected from mains. Only use fuses of the
same rating and power. The correct value is
specified on the device.
13
LED spot 1 to 4
14
Connection cable for the control unit
15
TV pin for placing on a stand
16
Fixation screw
26/40
00082823.DOCX, Version 1.0