Cleaning And Storing; Troubleshooting - LIVARNO LUX 1002-W Bedienungs- Und Sicherheitshinweise

sensor will respond even in brighter
ambient light conditions (e�g� daylight) (see
Fig� B)�
Turning the LUX control
„
decreases the sensitivity so that the motion
sensor will respond only in darker ambient
light conditions (e�g� at night) (see Fig� B)�
z Cleaning and storing
RISK OF BURNS! The light becomes hot
„
when switched on�
Always allow the outdoor spotlight to
„
completely cool down before cleaning it�
SHORT-CIRCUIT RISK! Water penetrating
„
into the casing can potentially cause a
short circuit�
Before cleaning, remove the mains fuse or
„
switch off the circuit-breaker for the circuit to
isolate the outdoor spotlight from the mains
power supply� Use a voltage tester to check
that the outdoor spotlight is isolated from
the power supply�
Do not immerse the outdoor spotlight in
„
water�
Make sure that no water gets into the
„
casing�
RISK OF DAMAGE! Cleaning the outdoor
„
spotlight incorrectly can potentially cause
damage�
Do not use corrosive cleaning agents,
„
brushes with metal or nylon bristles or sharp
or metallic cleaning implements such as
knives, hard spatulas or the like� They may
damage the surfaces�
Do not use any chemicals for cleaning�
„
Switch off the circuit-breaker or remove the
„
fuse for the circuit�
Use a voltage tester to check that the
„
outdoor spotlight is isolated from the power
supply�
Allow the outdoor spotlight to completely
„
cool down�
Wipe down the outdoor spotlight with a
„
slightly moistened cloth� Allow all parts to
dry completely�
12
GB
anticlockwise
3
If storing the outdoor spotlight away, keep
„
it in a dry place where it is safely out of the
reach of children�
z Troubleshooting
= Fault
= Cause
= Solution
= The outdoor spotlight fails to function�
= There is a fault with the power supply
or cable�
= Have it checked by a competent
person�
= The outdoor spotlight is incorrectly
adjusted�
= Use the control knobs to adjust the
settings properly�
= The wiring is incorrect�
= Have it checked by a competent
person�
= The detection range of the motion
sensor is badly adjusted�
= Readjust the detection range of the
motion sensor�
= The outdoor spotlight constantly
switches on and off�
= The outdoor spotlight constantly
responds to movement�
= Check the detection zone for moving
objects/animals�
= Check the adjustment of the outdoor
spotlight�
= Readjust the detection range of the
motion sensor�
= Adjust the illumination time�
= Adjust the sensitivity of the twilight
sensor�
= The outdoor spotlight gets hot�
= That is quite normal and not a fault�
= Make sure that the outdoor spotlight
is well ventilated�