Removing The Blades; Sharpening The Blades - Toro eS3000SD 72V Bedienungsanleitung

Figure 31
1. Blade (side previously measured)
2. Measurement (position used previously)
3. Opposing side of blade being moved into measurement
position
5. Measure from the tip of the blade to the flat
surface (Figure 32).
Note:
The variance should be no more than
3 mm (1/8 inch).
Figure 32
1. Opposite blade edge (in position for measuring)
2. Level surface
3. Second measured distance between blade and surface (B)
A. If the difference between A and B is greater
than 3 mm (1/8 inch), replace the blade with
a new blade; refer to
(page 29) and
30).
Note:
If a bent blade is replaced with a
new blade, and the dimension obtained
continues to exceed 3 mm (1/8 inch), the
blade spindle could be bent. Contact an
Authorized Service Dealer for service.
B. If the variance is within constraints, move to
the next blade.
6. Repeat this procedure on each blade.

Removing the Blades

Installing the Blades (page
Removing the Blades
Replace the blades if they hit a solid object, or if the
blade is out of balance or bent.
1. Place a woodblock between the blade and
mower housing to prevent the blade from
turning.
g343369
2. Hold the blade end using a rag or thickly padded
glove.
3. Remove the blade.
g343365
1. Spindle shaft
2. Adapter
3. Blade

Sharpening the Blades

1. Use a file to sharpen the cutting edge at both
ends of the blade
Note:
Maintain the original angle.
Note:
The blade retains its balance if the same
amount of material is removed from both cutting
edges.
1. Sharpen at original angle.
2. Check the balance of the blade by putting it on a
blade balancer
Note:
If the blade stays in a horizontal position,
the blade is balanced and can be used.
29
Figure 33
4. Curved washer
5. Nut
(Figure 34).
Figure 34
(Figure 35).
g343371
g000552