Safety Inspection - Upright MB20N/26 Betriebsanleitung

!
DO NOT use the work platform without safety drop-bar in place and
with the safety harness fitted.
3. S I
AFETY NSPECTION
1. Remove the rear chassis covers by means of the two top twist-locks and the two lift-
2. Ensure that the mast and jib are fully lowered. Remove the hydraulic oil filler cap and
3. Inspect the chassis area for oil leaks, loose parts, frayed cables and hoses and
W A R N I N G
This Safety Inspection shall be carried out by the owner immediately prior to
transporting this machine.
This Safety Inspection shall also be carried out by the user prior to use each day.
The procedure is to carry out the following 14 checks in order as follows.
and-turn catches at the sides. The cover is removed by sliding it backwards and
upwards. Use the central handle provided.
check that the hydraulic oil level is correct. Oil should be visible on the dip stick. Top
up as necessary using hydraulic oil Viscosity Grade ISO 46.
structural damage etc. Check that all cable connections to the solenoid valves are
intact.
3 S
AFETY
Elevating Assembly
!
I
NSPECTION
Figure 2: Work Platform
Platform Controller
Safety Drop-bar
Platform
Chassis Controls
Chassis
Page 3