Controls And Indicators; Elevating & Lowering The Work Platform - Upright MB20N/26 Betriebsanleitung

4 O
PERATION OF THE
C
ONTROLS AND
!
DO NOT operate the machine from the upper controls until the
platform entrance drop-bar is in the fully lowered position and your
safety harness has been fitted and attached.
E
LEVATING
!
ENSURE that no other persons are within 1 metre of the machine.
Be aware of the pothole protection bar hazard on both sides of the
machine.
LOOK up and around for obstructions before performing the lift or
drive functions.
DO NOT overload the platform.
DO NOT operate within 3 metres of any electrical power cables.
THIS WORK PLATFORM IS NOT ELECTRICALLY INSULATED.
NOTE: Chassis controls are for service use only.
1. Enter the Platform through the entrance at the rear of the MB20/26 and ensure that the
2. Before using the machine all local Safety Regulations involving helmets and restraining
3. Ensure that the 'ON/OFF Key Switch on the Upper Control Box is turned to the 'ON'
4. Check the Display L.E.D. is illuminated. If not, the battery may need recharging.
5. Check if the audible alarm sounds due to un-level ground. None of the functions can
Page 10
P C
LATFORM ONTROLS
I
The pre-operation safety checks should be carried out prior to operation. These checks
are detailed in the previous section. Operators who follow these guidelines will become
familiar with the controls and indicators on the machine.
This section summarises the controls and indicators in tabular form and provides more
detailed information.
W A R N I N G
& L
OWERING THE
Before operating the MB20 Work Platform it is imperative that the pre-operation Safety
Inspection has been completed and any deficiencies have been corrected. The
operator must also be fully trained in the use of this machine.
Before beginning any operation, the following checks should be carried out.
W A R N I N G
drop bar is in position. Raise and lock the entry step by means of the pedal in the
platform.
devices should be observed. Safety harness lanyards, not exceeding 1 metre in length,
should be attached to anchor points in cage floor.
position and both emergency stop buttons are off (twist clockwise if necessary).
work if the machine is not level.
NDICATORS
!
W
!
P
ORK LATFORM