Transportation; Machine Weights - Upright MB20N/26 Betriebsanleitung

5. T
RANSPORTATION
M
!
This work must not be carried out without the prior written permission
of UpRight Powered Access.
Forklifting is for transport only. See machine weights and ensure
that the forklift is of adequate capacity.
W
ACHINE EIGHTS
Before transporting or lifting the MB20N/26 machine be aware of its weight. It is very
important to realise that the centre of gravity of the stowed machine is approximately
80 cm above ground and in the plane of the energy chain which is located on the back
of the mast.
MB20N CE Version=
MB20N US Version=
MB26 CE Version =
MB26 US Version =
In cases of particular difficulties with lifting or shipping it is possible to remove the
single block ballast from the machine. Remove the 13 screws connecting the ballast
cover to the mast. Undo the 4 bolts connecting the ballast to the mast and use a forklift
to remove the ballast block. The ballast block weighs 850 kg on the CE version and
1300kg on the US (ANSI) version.
W A R N I N G
L F
IFTING BY ORK
D A N G E R
!
Adjust the forks so that
the minimum clearance
between them is 800mm
as shown above.
Approach the machine
from either side but place
the fork as close as
possible to the front wheel
as shown.
2550 kg
3000 kg (6615 lbs)
2650 kg
3150 kg (6945 lbs)
!
-L
IFT
!
Front
800mm
5 T
RANSPORTATION
Figure 10: Lifting by Forklift
Page 13