Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
T
RAVEL WITH
Refer to Tables 1 & 2 for controls and indicators.
1. Verify that both Lower and Upper Control Console Emergency Stop Button is in the
'ON' position (turn clockwise to reset).
2. Climb into the Platform and check that the Keyswitch is turned to the 'ON' position and
that the Drive Button is illuminated. Ensure that the drop bar is in position.
3. Check that the route is clear of persons, obstructions, pot holes or ledges and is
capable of supporting the wheel loads. Also, check that the clearances above, below,
and to the side of the Work Platform are sufficient.
4. To steer the MB20/26, activate the Deadman Switch while pushing the Steering
Thumb-switch, on top of the Joystick, LEFT or RIGHT to turn the wheels. Observe the
tyres while manoeuvring to ensure correct direction.
NOTE: Steering is not self-centring. The wheels must be returned to the straight ahead
position by operating the Steering Switch.
T
RAVEL WITH
C A U T I O N
!
If the machine stops driving and the Tilt Alarm sounds, lower the
Platform immediately.
Using the Emergency Override functions, move the machine to a
level location before re-elevating the platform.
Travel with platform elevated ONLY on firm and level surfaces.
Refer to Tables 1 & 2 for controls and indicators.
NOTE: The Work Platform will travel at reduced speed when in the elevated position.
1. Check that the route is clear of persons, obstructions, pot holes or ledges and is
capable of supporting the wheel loads. Also, check that the clearances above, below
and to the side of the Work Platform are sufficient.
2. Ensure that the pothole guards remain in the extended (down) position during elevated
travel.
E
MERGENCY
In any emergency situation, the immediate action is to push the red "Emergency Stop"
button. This will instantly cut of all electrical power to the controls. The button must be
twisted in a clockwise direction in order to recommence control.
However, the switch should be reset only when it is safe to do so.
If the Audible warning alarm sounds, normal control functions will cease to operate.
This will be due to the following problem;
• The Tilt Sensor has been activated
NOTE: that during emergency operation, controls will operate only at a fixed, slow speed
and will not allow the raising of the Booms. The Booms can only be lowered.
4 O
PERATION OF THE
W
P
ORK
LATFORM
W
P
ORK
LATFORM
S
ITUATIONS
P
LATFORM
L
OWERED
E
LEVATED
!
C
ONTROLS
Page 11
Werbung
Kapitel
Inhaltsverzeichnis
