Putting Into Operation; Maintenance; Spare Parts - IARP F300 Betriebsanleitung

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante

19. PUTTING INTO OPERATION

If the cabinet has been sharply tilted while being sited or for mounting of accessories, it must be left to stand for
at least three hours before being started to allow the lubricating oil to settle in the compressor.
Failure to do so can cause total destruction of the compressor refrigerating system.
Check that the voltage on the identification plate is the same as that of the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE REFRIGERATOR WILL
HAVE TO BE CONNECTED IS TO BE PROTECTED BY A VERY
SENSITIVE DIFFERENTIAL SWITCH (Rc=16A,Dc=30mA); IT
IS ALSO TO BE LINKED TO THE GENERAL EARTHING PLANT.
Earthing is necessary and compulsory by law.
Absolutely never use reduction units, patch cords, adapters or multiple
socket outlets to connect the counter. DIRECTLY connect the equipment
to the mains.
The cable should be fully extended and located where it is unilikely to be struck, caught or stepped
on, away from water and the other liquids and heat sources and must not be damaged. In case of breakage of the
power cable of the cabinet, it must be replaced by the manufacturer or by instruction it change of it.
Follow the manufacturer's instructions to install the unit, using qualified personnel and complying with the electrical
regulations for the specific country.
Incorrect installation may cause injury and damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability for any damage to people or things due to
incorrect observance of this rule.

20. MAINTENANCE

WARNING! Maintenance must be carried out by technical staff trained and enabled for intervention on the
flammable refrigerants.
WARNING! Any work carried out on the appliance by the user strictly requires the power plug being
disconnected from the mains socket.
ATTENTION! Use protective shoes and gloves during maintenance operations.
OPERATION
Cleaning of external surfaces
Cleaning of accessible internal parts (no use of tools)
Seals intactness check
Water collection tank cleaning
Checking and cleaning the condenser if necessary
Replacement components and parts
* Recommended frequency for optimal counter operation and maintenance of full efficiency.
Any other maintenance operation not planned in the previous points should be carried out by the
support centres authorised by our dealers or by qualified staff.
21. INSTRUCTIONS FOR CORRECT INSTALLATION AND
MAINTENANCE
The user and maintenance instructions are found in the User Manual available on the website www.eptarefrigeration.com.
The installation instructions dedicated to expert personnel are available:
• From the service network
• In some product categories in paper form delivered with the product.
22. PROFESSIONAL REPAIR SERVICES
The services are provided by our service network that can be consulted in the contact area at the web address: www.eptarefrige-
ration.com.

23. SPARE PARTS

The spare parts and the information to repair the unit are available for at least 8 years after the product is declared out of production
at the following web address: www.epta-service.com/service/.
The credentials are provided on request by sending an email to: servicesupport@eptarefrigeration.com
F300 - F400 - F500
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
FREQUENCY
Based on use
Based on use
MAINTENANCE
Ordinary
Ordinary
Yearly * Ordinary
Yearly * Ordinary
Yearly * Ordinary
- Extraordinary
1 7 / 4 8
PAGE
N° DOC
AUTHORISED STAFF
User
User
Technical support
Technical support
Technical support
Technical support