IARP F300 Betriebsanleitung Seite 11

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
TRANSLATION OF ORIGINAL INSTRUCTIONS
SAFETY ADVICE
1.
WARNING! DO NOT DAMAGE THE REFRIGERANT CIRCUIT.
WARNING! DO NOT DAMAGE THE INNER OR OUTER WALLS OF THE APPLIANCE:
THE REFRIGERANT FLUID CIRCUIT MAY BE DAMAGED. IN CASE OF DAMAGE
TO THE WALLS, DO NOT START THE APPLIANCE AND CONTACT A QUALIFIED
SERVICE TECHNICIAN.
WARNING! THIS APPLIANCE MUST ONLY BE INSTALLED BY SUITABLY
QUALIFIED PERSONNEL IN ORDER TO REDUCE THE RISKS CONNECTED WITH
FLAMMABILITY.
WARNING! KEEP THE VENTILATION OPENINGS IN THE APPLIANCE CASING
OR IN THE RECESSED STRUCTURE CLEAR OF OBSTRUCTIONS.
WARNING! NEVER USE MECHANICAL DEVICES OR ANY OTHER MEANS TO
ACCELERATE THE DEFROSTING PROCESS, OTHER THAN THOSE RECOMMENDED
BY THE MANUFACTURER.
WARNING! DO NOT USE ELECTRICAL APPLIANCES INSIDE THE COMPARTMENTS
OF THE APPLIANCE FOR STORING FROZEN FOODS IF THESE ARE NOT THOSE
RECOMMENDED BY THE MANUFACTURER.
Isobutane is a natural gas that doesn't affect the environment but is
inflammable.
It is therefore essential to ensure that all refrigerant pipes are not
damaged before connecting the appliance to the mains supply.
Every 8 gr. Of refrigerant, the installation room must have a 1 m³
minimum volume.
The amount of refrigerant of the appliance is indicated on the rating plate
of the device. In the event of leakage of the refrigerant, avoid using
open flames or sources of ignition in the vicinity of the area of the leak.
Be careful not to not damage the refrigerant circuit pipes during positioning,
installation and cleaning.
AVOID USING NAKED FLAMES OR SPARKS INSIDE THE APPLIANCE.
IN THE EVENT OF DAMAGE:
• Keep the appliance far from flames or ignition sources.
• Ventilate the room well for a few minutes.
• Switch off the equipment, remove the power supply plug.
• Inform customer service.
• The higher the refrigerant content in the equipment, the larger the room must be hosting
the equipment.
• In rooms that are too small, a mix of flammable air and gas can form in the event of a leak.
F300 - F400 - F500
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
ENGLISH
1 1 / 4 8
PAGE
N° DOC