IARP F300 Betriebsanleitung Seite 18

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
24. OUTER CLEANING
WARNING! TURN OFF POWER SUPPLY TO THE CABINET BY DISCONNECTING THE POWER
PLUG BEFORE CLEANING.
For a good preservation of the cabinet's body a periodical cleaning is necessary.
1. EXTERNAL BODY:
When necessary, the external body should be cleaned with a cloth and a neutral soap and water solution.
2. STAINLESS STEEL SURFACES:
pads etc. which will spoil the finish of the stainless steel.
3. SURFACES IN PLASTIC MATERIAL:
no circumstances should alcohol, methylated spirits or solvents be used.
4. GLASS SURFACES:
can leave a film of calcium on the surface of the glass.
WARNING! Do not use jet of water to clean the cabinet: electrical wiring could be damaged.
WARNING! Never use mechanical devices or any other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
25. INNER CLEANING
WARNING! TURN OFF POWER SUPPLY TO THE CABINET BY DISCONNECTING THE
POWER PLUG BEFORE CLEANING.
If , however, the layer of frost on tank walls exceeds 4/5 mm in thickness, you should completely
defreeze the appliance as follows:
1. Place the goods in special refrigerated containers, kept at the same temperature.
2. Put a basin of warm but not boiling waterinto the tank and close the glass lids for about 30
minutes.
3. Remove the internal draining plug and place under the body (if it's possible) a tray for water
discharging.
4. Proceed with washing and drying the internal chamber with a cloth using neutral PH detergent
and fresh water.
5. Subsequentely, replace draining plug, plug in again and wait till the appliance reaches the right
temperature before filling it again.
Do not use any aggressive or abrasive cleaning agents.
Never use a water hose or a high-pressure jet to clean the cabinet.
WARNING! Do not use jet of water to clean the cabinet: electrical wiring could be damaged.
WARNING! Never use mechanical devices or any other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
26. TEMPERATURE SETTING AND CONTROLS (Mechanical)
The appliance is provided with a thermostat for automatic maintenance of the temperature inside the tank.
This temperature adjuster is gauged by the factory and should not be touched by the user.
Only if the average internal temperature is too cold or not cold enough should the knob turned.
The numbers on the regulation plate are not related to temperature values but only to knob reference position: a higher number
corresponds to a lower temperature.
Use average temperature settings to ensure optimum performance and to save energy.
A) Thermostat
B) Warning Indicator (Red):
When this red warning light comes on for a
prolonged period of time, it means that the
freezer is not functioning properly and the
temperature is too high. This warning light may
come on for a brief period when the lid is left
open for an extended period of time.
C) Power Supply Indicator (Green):
green light will come on and stay on while the
appliance is connected and is operating
normally.
D) Thermometer
F300 - F400 - F500
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
Wash with warm water and mild detergent, rinse well and dry with soft cloth. Avoid scouring
Wash with warm water and mild detergent, rinse well and dry with soft cloth; under
Only use products specifically designed for glass cleaning; It is not advisable to use ordinary water which
The
B C
1 8 / 4 8
PAGE
N° DOC
A
D