Putting Into Operation; Periodical Maintenance - IARP AB series Gebrauchs- Und Bedienungs Anleitungen

During transports operation put the wood part
under the door in order to avoid possible door-
frame foldings.

PERIODICAL MAINTENANCE

Any further adjustments on the refrigerator necessarily require the electric plug to be removed.
Check periodically the supply cable in order to detect any damage. If the power supply cable is da-
maged, don't use the equipment and don't try to repair it: to prevent any risk, it must be replaced by
the manufacturer, by a member of the after-sales service staff, or anyway by a person having similar
qualifications. In any case, none of the protective elements (the grill, the carter) must be removed by
non qualified staff. Absolutely avoid using the refrigerator without such protection.
For a good preservation of the cabinet's body a periodical cleaning is necessary.
EXTERNAL BODY: When necessary, the external body should be cleaned with a cloth and a neutral
soap and water solution.
STAINLESS STEEL SURFACES: wash with warm water and mild detergent, rinse well and dry with
soft cloth. Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL: wash with warm water and mild detergent, rinse well and
dry with soft cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
SEASONAL WORK
When the unit is kept unused for a long time, please take note of the following procedures:
- unplug the unit;
- clean and dry well the tank;
- leave the door open to avoid possible formation of bad smells;
- cover the unit with a curtain, place it in a dry room and sheltered from the atmospheric agents.

PUTTING INTO OPERATION

Check that the voltage on the identification plate is the same
as that of the network. THE ELECTRICAL SUPPLY
LINE TO WHICH THE REFRIGERATOR WILL
HAVE TO BE CONNECTED IS TO BE PROTECTED
BY A VERY SENSITIVE DIFFERENTIAL SWITCH
(Rc=16A,Dc=30mA); IT IS ALSO TO BE LINKED TO
THE GENERAL EARTHING PLANT.
Earthing is necessary and compulsory by law. Absolutely
never use reduction units, patch cords, adapters or multiple
socket outlets to connect the counter. DIRECTLY connect
the equipment to the mains.
The manufacturer disclaims all responsability for any damage
to people or things due to incorrect observance of this rule.
-7-