Further Information; Putting Into Operation - IARP MINIGELE Gebrauchs- Und Bedienungs Anleitungen

7.5 FURTHER INFORMATION

Take out packaging and clean all the cabinet using warm water together with 5% of neutral soap then dry it
with a soft cloth; for the glass parts only use specific products, avoiding the use of water which can leave on the
glasses limestone residues.
Keep the freezer stable to avoid vibrations and noise.
10 mm
7.6

PUTTING INTO OPERATION

If the cabinet has been sharply tilted while being sited or for mounting of accessories, it must be
left to stand for at least three hours before being started to allow the lubricating oil to settle in
the compressor.
Failure to do so can cause total destruction of the compressor refrigerating system.
Check that the voltage on the identification plate is the same as that of the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE REFRIGERATOR WILL HAVE TO BE CONNECTED
IS TO BE PROTECTED BY A VERY SENSITIVE DIFFERENTIAL SWITCH (Rc=16A,Dc=30mA); IT
IS ALSO TO BE LINKED TO THE GENERAL EARTHING PLANT.
Follow the manufacturer's instructions to install the unit, using qualified personnel and complying
with the electrical regulations for the specific country.
Incorrect installation may cause injury and damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability for any damage to people or things due to incorrect
observance of this rule.
Earthing is necessary and compulsory by law. Absolutely never use reduction units, patch cords,
adapters or multiple socket outlets to connect the counter.
DIRECTLY connect the equipment to the mains.
The cable should be fully extended and located where it is unilikely to be struck, caught or stepped
on, away from water and the other liquids and heat sources and must not be damaged.
In case of breakage of the power cable of the cabinet, it must be replaced by the manufacturer
or by instruction it change of it.
It is fundamental to comply with the distances indicated
(cm) for correct installation of the equipment.
• Cabinet must be installed on a perfectly even surface, far away
from any heat source (radiators, stoves, etc) including sun rays.
• It is necessary that the capacitor unit is in the free air exchange
condition, therefore the ventilation zones must not be
obstructed by boxes or otherwise.
• Install and position the unit in such a way so as to allow easy
access to the power socket.
• Never place containers of liquid on or immediately above the
ticket counter; should the content spill out, it would damage
the counter.
THE REFRIGERATOR IS NOT SUITABLE FOR WORKING
IN DANGEROUS ENVIRONMENT WITH RISK OF FIRE,
EXPLOSIONS OR RADIATIONS.
Operation is regular with ambient temperature indicated
on technical data plate.
-23-