8. Menu guidance of the user interface
8.1 Main menu "Measurement"
EN
Function
Unit
Setting the unit of the measuring range of the connected transmitter
Setting range:
mA → Ω → bar → mbar → psi → hPa → kPa → mmH
→ K → % → USER → V
Measuring range start
Setting of the start value of the measuring range of the connected transmitter
(e.g. -30 for a measuring range of -30 ... +120 °C)
Setting range: -9999 ... 99999
Measuring range end
Setting the end value of the measuring range of the connected transmitter (e.g.
120 for a measuring range of -30 ... +120 °C)
Setting range: -9999 ... 99999
Measuring range format
Setting the decimal point for the measuring range of the connected transmitter.
Setting range: 0 ↔ 0.0 ↔ 0.00 ↔ 0.000 ↔ 0.0000
Span (only DIH52)
The current measured value is applied as max. adjustment for the sensor.
Attention: Cannot be used for all HART
Zero point (only DIH52)
The current measured value is applied as min. adjustment for the sensor.
Attention: Cannot be used for all HART
Damping (only DIH52)
Input damping for damping the measured value.
Setting range: 0.0 ... 999
Adress (only DIH52)
Setting the HART
for the standard current loop mode, this address must always be set to 0.
Setting range: 0 ... 15
24
®
®
address of the assigned transmitter in the multidrop mode;
®
O → mH
O → inHg → °C → °F
2
2
transmitters
transmitters
WIKA operating instructions models TIF50, TIF52
Factory
setting
mA
4,000
20,000
00.000
-----
-----
0.0
0