Hints And Warnings - Siemens SIPROTEC 7SJ62 Handbuch

2

Hints and Warnings

7SJ62/63/64 Additional Information
C53000-B1174-C170-1
The warnings and notes contained in this booklet and in the associated manuals serve
for your own safety and for an appropriate lifetime of the device. Please observe them
Warning!
During operation of electrical equipment, certain parts of these devices are under high
voltage. Severe personal injury or significant equipment damage could result from
improper behavior.
Only qualified personnel shall work on this equipment or in the vicinity of this
equipment. These personnel must be familiar with all warnings and service
procedures described in this booklet and the associated manual, and with safety
regulations.
Prerequisites to proper and safe operation of this product are proper transport, proper
storage, setup, installation, operation, and maintenance of the product, as well as
careful operation and servicing of the device within the scope of the warnings and
instructions of this manual.
In particular, the general facility and safety regulations for work with high-voltage
equipment (e.g. ANSI, IEC, EN, or other national or international regulations) must be
observed. Noncompliance may result in death, injury, or significant equipment
damage.
QUALIFIED PERSONNEL
Within the meaning of safety precautions of this manual and the instructions, qualified
personnel are those persons who are qualified to set up, install, place into service, and
operate this device, and who possess the following qualifications:
Training and instruction (or other qualification) for switching, grounding, and
designating devices and systems in accordance with established safety practices.
Training or instruction in accordance with safety standards for care and use of
certain safety equipment.
First aid training.
Note
This additional sheet was created particularly for application of the 7SJ62/63/64
protective relay applied for the protection of explosion proof motors of protection type
increased-safety "e".
A description of all device features and setting parameters would be too
comprehensive for this documentation.
You can look up further information and a detailed description of all setting parameters
in the manual (Order No. C53000–G1140–C147)
For general information on the operation and configuration of SIPROTEC
please refer to the SIPROTEC
C151).
Therefore, this additional sheet is only valid in connection with the mentioned
manuals.
®
4 System Description (Order No. E50417–H1176–
Hints and Warnings
®
4 devices,
23