Unpacking - Pfannenberg DTS-Serie Betriebsanleitung

ENG
4.3 Storage
ATTENTION
Loss of warranty!
Failure to observe the storage conditions will lead to loss of warranty.
Note the following points for storage of the unit:
• Observe the permissible storage temperature of -20 ... +70 °C (-4 ... +131 °F).
• Always store the unit in its operating position.
4.4

Unpacking

WARNING
Risk of injury!
Risk of injury for persons due to the heavy weight of the units!
The total weight must be observed when transporting the unit.
• Observe the weight according to section "Dimensions", Page 24.
• Always transport the unit with several persons or suitable lifting gear.
• Use personal protective equipment.
CAUTION
Risk of cutting and injury!
Risk of cutting and injury due to production-related, sharp sheet metal edges on the unit.
• Use personal protective equipment (cut-proof gloves).
• Handle with care.
Unpacking the unit
1. Check the packing for transport damages.
2. Remove all transport and packing material.
3. Check the unit for transport damages or other damages after unpacking.
4. If no damage is found, dispose of the packing material in an environmentally friendly way.
If damages occur during transport, observe the following points:
• Notify the transport company and the manufacturer in writing. Always state type designation and serial number in
addition.
• Keep the packing material.
• Make a note of external and internal damages.
• Document damage (e.g. by photos).
• The "General Conditions for Deliveries and Services" of the ZVEI (Central Association for the German Electrotechnical
Industry) shall apply in the latest version.
NOTE
The unit should only be sent back in the original packing to avoid transport damages during return transport.
Operating Manual | Attachment and Installation Cooling Units | Standard Controller (SC) – 400 / 460 V, 3~ | 086100123 29/68